Worldlawn 28? Manuel de l'opérateur télécharger pdf (Page 7)

C. Reduce speed when making sharp turns and when turning on

hillsides.

● Do not operate the mower under the influence of alcohol or drugs.

● Before leaving the operator position or leaving the mower unattended,

shift the transmission into neutral, place the neutral latches in the neutral

lock position, and release the Blade Drive Lever. Shut the engine off.

● Shut the engine off and wait until the blades come to a complete stop

before removing the grass catcher.

● Never raise the mower deck while the blades are rotating.

● Always park the mower and/or start the engine on a level surface.

● Do not pass or stand on the grass discharge side of any mower while

the engine is running. Stop operation when another person approaches.

FIG 4.

FIG 4

MAINTENANCE AND STORAGE

Allow only trained personnel to service the mower.

● Disconnect the spark plug wire from the spark plug to prevent

accidental starting of the engine when servicing, adjusting, or storing the

mower.

● If the mower must be tipped to perform maintenance or adjustment,

remove the battery and drain the gasoline from the fuel tank.

● To reduce potential fire hazard, keep the engine free of excessive

grease, grass, leaves, and accumulations of dirt.

● Be sure the mower is in safe operating condition by keeping nuts,

bolts, and screws tight. Check the blade bolts and nuts frequently to be

sure they are tight.

● If the engine must be running to perform a maintenance adjustment,

keep hands, feet, clothing, and other parts of the body away from the

blades and other moving parts.

● Do not overspend the engine by changing governor settings. To be

sure of safety and accuracy, have an authorized dealer check maximum

engine speed with a tachometer.

● The engine must be shut off before checking the oil or adding oil to

the crankcase.

● Allow the engine to cool before storing the mower in any enclosure

such as a garage or storage shed.

● Always store gasoline in a safety-approved, red container.

● Caution must be taken while maintenance is being done to battery.

Battery contains corrosive acid which can burn your skin and clothing.

● Keep battery away from fires. Short circuit of battery can cause

explosion.

● Drain and refill the transmission oil yearly- use one pint of SAE30.

● Grease Fittings are provided on important parts requiring lubrication.

MOWER OPERATION

CAREFULLY READ AND UNDERSTAND ALL SAFETY

INSTRUCTIONS BEFORE ATTEMPTING TO OPERATE THE

MOWER.

INITIAL RUN PROCEDURES

·Check the belts for proper tension at 2, 4, and 8 hours.

·Check the steering control rods for neutral adjustment .

·Check the tires for proper pressure.

Drive wheels: 30 PSI (210kPa)

·Check for loose hardware. Tighten as needed.

·Check the safety switches for proper adjustment:

The engine will crank, but not start, if the mower is not

in neutral.

The engine will crank, but not start, if the blade drive

lever is engaged.

The engine should start if the transmission is in neutral

and the blade drive lever is disengaged.

·Check to make sure that all the fittings have been lubricated.

MOWER OPERATION

READ AND UNDERSTAND THE SAFETY INSTRUCTIONS

BEFORE ATTEMPTING TO OPERATE THE MOWER

BEFORE STARTING THE ENGINE

Check oil level in the engine.

Fill the fuel tank with clean, lead-free, gasoline.

Open the fuel line shut-off on the bottom of the fuel

tank.

NOTE:

·The transmission must be in neutral.

·The blade drive lever must be disengaged.

·Operator presence levers must be released.

·Steering levers must be in the neutral lock position.

START THE ENGINE

When starting a cold engine, move the throttle control to choke position.

When restarting a warm engine, move the throttle control to the

mid-way position.

BLADE DRIVE

Squeeze and hold the operator presence levers (engaged). Push the

mower blade drive lever forward to engaged position. The blades will

rotate at high speed. Pull the mower blade drive lever backward to

disengaged position to stop the blades. FIG 5.

THE BLADE TIP SPEED ON 28’’ IS 14,240 FEET PER MINUTE

1 2 3 4 5 6 7 8 9 10 11 12 ... 19 20

Commentaires sur ces manuels

Pas de commentaire

Worldlawn 28? Manuel de l'opérateur Page 7

Commentaires sur ces manuels