Worldlawn 28? Manuel de l'opérateur télécharger pdf (Page 26)

 Use 18# (80-90 gear lube) gear oil 0.26quart (0.25liter) in gear case; use funnel to fill.

 Install filter in gear case; tighten. Clean gear case surface thoroughly. (See FIG 16)

FIG 16

6. TROUBLESHOOTING

6.1 MOWER PULLS LEFT OR RIGHT

Check air pressure in tires, 30PSI（210kPa）.

6.2 MOWER CUTS UNEVENLY

 Check air pressure in tires; 30PSI（210kPa）.

 Check deck leveling.

 Check blades tip to tip for straightness.

Note: The front of the mower deck will be approximately 1/8’’- 1/4’’ lower than the back of the mower deck; this is the

“rake” of the deck.

6.3 ENGINE WILL NOT START

 Make sure there is fuel in the fuel tank and that the fuel valve is open.

 Check that the blade drive is disengaged and the ignition switch is in the “ON” position.

 Check that the spark plug wire is properly connected.

 Make sure the transmission is in neutral.

 Check for loose or faulty wiring connections.

 Check for corrosion at all wiring connections. Even minor corrosion may cause a faulty connection. Clean connector

terminals thoroughly with electrical contact cleaner, apply dielectric grease and reconnect.

NOTE: After carefully checking the above steps, attempt to start the engine. If it does not start, contact your

authorized service dealer.

IMPORTANT: It is essential that all operator safety mechanisms be connected and in proper operating condition

prior to mower use.

When a problem occurs, do not overlook the simple causes. For example, starting problems could be caused by an

empty fuel tank.

The following table lists some of the common causes of trouble.

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 32

Pas de commentaire

Worldlawn 28? Manuel de l'opérateur Page 26